Image Posting - Sony SNC-EMX30R User Manual

Network camera
With a 0.0.0.0 setting, the encoder for the stream operates in multi-unicast mode (copying of
data stream in device). The camera supports multi-unicast connections for up to five
simultaneously connected receivers.
Duplication of data places a heavy demand on the CPU and can lead to impairment of the
image quality under certain circumstances.
Port
Enter the port address for the stream here.
Streaming
Click the checkbox to activate multicast streaming mode. An activated stream is marked with
a check. (Streaming is typically not required for standard multicast operation.)
Multicast packet TTL
A value can be entered to specify how long the multicast data packets are active on the
network. If multicast is to be run via a router, the value must be greater than 1.
IGMP version
Set the multicast IGMP version to comply with the device.
Click Set to apply the changes.
4.7.6

Image Posting

A target account must first be defined to use JPEG posting and for the export of recordings.
JPEG
Save individual JPEG images on an FTP server at specific intervals.
Image size
Select the size of the JPEG images that are to be sent from the camera. JPEG resolution
corresponds to the highest setting from the two data streams.
File name
You can select how file names will be created for the individual images that are transmitted.
–
–
–
VCA overlays
If you have enabled the display of VCA overlays on the Appearance page, select the VCA
overlays check box to have the overlays also visible in the JPEG image.
Posting interval
Enter the interval in seconds at which the images are sent to an FTP server. Enter zero for no
images to be sent.
Post JPEG from camera
(Only applicable to SNC-HMX cameras)
Click the checkbox to select the cameras from which JPEG images are sent. An enabled video
input is indicated by a check mark.
Target
Select the target account for JPEG posting.
Sony Corporation
Overwrite The same file name is always used and any existing file will be overwritten with
the current file.
Increment A number from 000 to 255 is added to the file name and automatically
incremented by 1. When it reaches 255 it starts again from 000.
Date/time suffix The date and time are automatically added to the file name. When
setting this parameter, ensure that the unit's date and time are always correctly set.
Example: the file snap011005_114530.jpg was stored on October 1, 2005 at 11:45 and
30 seconds.
User manual
Configuration | en 93
2019-07 | V01 | DOC