AEG BPK742320M User Manual page 44

44 www.aeg.com
13.1 What to do if...
Problem
You cannot activate or oper-
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The core temperature sensor
does not operate.
The display shows F111.
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
on.
The Child Lock is on.
The door is not closed cor-
rectly.
The fuse is blown.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is an electrical fault.
You left the dish in the oven
for too long.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Turn on the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
• Turn off the oven with the
house fuse or the safety
switch in the fuse box
and turn it on again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.