Registering Procedure And Print Format - TEC FS-1450 Owner's Manual

10. REGISTERING PROCEDURE AND PRINT FORMAT

Before starting sale entries, read through the following instructions:
When opening the cash drawer, be careful not to let the drawer hit any person.
TRAINING MODE is available:
If you are a beginner in operating this register, ask the store manager for practicing in the TRAIN-
ING MODE.
During your operations, the following may occur:
• Errors ...
A tone continuously sounds and the keys on the keyboard are locked. In this case, depress
the [C] key to cancel the error status. Then remove the cause of the error and perform the
operation again.
• Other errors requiring Manager Intervention ...
When an error occurs and you cannot think of the cause or the same error occurs again, call
your manager.
• Receipt or Journal Paper-End is detected ...
When an error tone sounds and the "AMOUNT" portion of the display is flickering, the receipt
or journal roll is about to end. In this case, the error cannot be canceled by the [C] key.
Replace the paper roll with a new one, referring to the paper installing/removing operations in
Chapter 15 and Chapter 6.
• Printer Motor-Lock Condition is detected ...
If "Error" is indicated in the display panel ("AMOUNT" portion), the Printer Motor is locked due
to paper jam, etc. Turn the Power Switch to OFF, and remove the cause of the motor-lock.
Refer to Chapters 12 and 13.
CONDITION SETTING TO START TRANSACTION ENTRIES
Mode Lock: Insert the "REG" key and set it to the "REG" position.
WARNING!
- 26 -
EO1-11097