Table of Contents
Advertisement
Customizing the Function Settings
The symbols that might appear next to each listed wireless
network in the network list are as follows:
Category
Icon
Defi nition
Connected
When the BD player is
turned on, it will connect
to the wireless network
displaying this symbol.
Typically, this is the last
wireless network connected
before powering down.
Saved
The wireless network prop-
erties have been saved in
the BD player's memory.
Wireless Security
The wireless network data
is not encrypted.
The wireless network data
is encrypted; a 'security key'
must be entered so that the
BD player can share data
over the network.
The wireless network data
is encrypted; the encryption
scheme is not supported by
the BD player.
Wireless Protocol
The wireless network sup-
a
ports 802.11a
The wireless network sup-
b
ports 802.11b
The wireless network sup-
g
ports 802.11g
The wireless network sup-
n
ports 802.11n
Signal Strength
Strong Signal
Good Signal
Medium Signal
Weak Signal
No Signal
I.
Connection to the wireless Network which you
select
1. Press
/
to select Wireless, then press OK to confi rm.
the following screen will appear.
Network List
WiFi Protected Setup (WPS)
Manual
IP Settings
2. Press
/
to select Network List, then press OK. A
list of existing wireless networks near the BD player will
appear (It may take several seconds for this list to be
created). For example:
Network List
a
WiFi
WiFi
b g n
a
WiFi
b
g
WiFi
WiFi
b
g
3. Press
/
to select the desired wireless network, and
press OK to confi rm.
a. If the BD player is connected to an Unencrypted
Wireless Network, a menu similar to the following will
appear:
WiFi-me
Connect
WPS Pin
4. Press
/
to highlight Connect, and press OK. If the
wireless network is functioning,
"Connection to XXX...Success" will appear on the TV.
5. Press OK to close the message. The BD disc player is
now connected to the network. From now on, when you
turn on the player, it will automatically connect to the
network; there is no need to repeat these steps again.
Note: If you do not see this message, the BD player was
not able to connect to the network.
b. If the BD player is connected to an Encrypted
Wireless Network, a menu similar to the following will
appear:
WiFi-me
Password
Connect
WPS Pin
Press ENTER to open keyboard
4. Press ENTER to activate the on-screen keyboard.
Carefully enter the network password by using the
/
/
to highlight the desired letter on the keyboard,
and then pressing OK. (If you make a mistake, use the
backspace
key to erase the mistake.)
WiFi-me*
Panda
dlink_media
NTGR 11g
Airport_SN
Delete
Cancel
icon and a message
Cancel
/
29
Advertisement
Table of Contents
