Assembly And Installation - Frigidaire EFRB200 User Manual

ASSEMBLY AND INSTALLATION

This Use and Care Guide provides specific operating instructions for your model. Use this unit
only as instructed in this Use and Care Guide. Before starting the unit, follow these important
first steps.
LOCATION
• Choose a place that is near a grounded electrical outlet. Do not use an extension cord or an
adapter plug.
• If possible, place the unit out of direct sunlight and away from the range, dishwasher or other
heat sources.
• For optimum performance, this product should only be used indoors under normal ambient
conditions.
• The appliance must be installed on a floor that is level and strong enough to support a fully
loaded unit.
• If the appliance has been placed in a horizontal or tilted position for any period of time, please
wait at least 24 hours before plugging the unit in.
INSTALLING THE CASTERS
Follow the steps below to install the casters.
1. Empty the inside of the cabinet completely and lay the Keg Cooler down on its side.
We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent
dents or scratches.
2. Insert the casters into the holes on the bottom corners of the cabinet. Tighten each caster by
turning the head of the bolts clockwise with a wrench (not provided in the kit).
3. Once all four casters have been tightened, stand the cabinet in its upright position.
NOTE: Two of the casters include locking mechanisms to ensure the unit does not
slide on hard floors. These two locking casters should be fastened at the front end
of the unit, with the unlocked casters fastened on the rear end.
INSTALLING THE BEER TAP
There are notches on the bottom of the dispensing tower that line up with grooves inside the
opening on the top of the Keg Cooler. Align the dispensing tower with the opening on the top of
the unit, then place inside and twist clockwise until secure. Use four screws to fasten the beer tap.
Pay attention to use the thin black gasket (9) for assembly (see illustration). If you find this to be
a tight fit, apply some soapy water to the gasket to make the tower easier to twist into place.
Also see illustration showing hose connections to CO regulator to the beer tap.
2
6