Replacing Carbon Brushes - Makita 5007F Instruction Manual

1.
Triangular rule
Combmahon
Pressure treated/
Wet lumber
Fine
cross cuts
-1
1 .
Lima mark
General purpose blade for fast and smooth np, crosscuts and miters.
Oesigned for fact cumng in pressure treated and wet lumber.
For sand-free cuts cleanly against the grain.
1.
Brush holder cap
2.
Swewdnver
ACCESSORIES
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip
in
the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To
maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Setvice Centers,
always using Makita replacement parts.
CAUTION:
These accessories or attachments are recommended
for use with your Makaa
tool
specified
in
this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
12