Pack Contents/Parts List; General Information - Batavia ?THOR MULTISAW Operating Instructions Manual

English

1. Pack contents/parts list

1. Front handle
2. On/Off switch for the laser
3. Access switch for the protective hood
4. On/Off switch for the mini circular saw
5. Rear handle
6. Mains cord with plug
7. Vents
8. Cover for carbon brush (× 2)
9. Cutting depth limiter
10. Support flange
11. Spindle
12. Clamping flange
13. Clamp bolt
14. Base plate
a. Cutting line guide (× 2)
15. Parallel guide
a. Locking knob
b. Scale
16. Protective hood
17. Dust extractor connection
18. Spindle lock
19. Cutting depth scale
20. Laser
21. Battery compartment
a. Battery compartment lid*
b. Screw*
c. Button cell
22. Suction hose
23. Star hex key
24. Transport case
25. Diamond cutting disc
26. Multi Material (MM) saw blade, 24 teeth
The product contents include one CR2032
battery.
Parts labelled with * are not represented in
the overview. For this, refer to diagram 9
and the relevant section within the user
manual.

2. General information

Reading and storing the user
2.1.
manual
This user manual accompanies this
710 W Mini Circular Saw (referred to
below simply as "product"). It con-
4
7063051-Thor-Compact-Ma-1804-30.indb 4
tains important information about safety,
usage and care.
Before using the product, read the user
manual carefully. Pay particular attention to
the safety instructions and warnings. Failure
to comply with the instructions in this user
manual may result in severe injury or dam-
age to the product.
Comply with applicable local or national
regulations concerning the use of this prod-
uct. Keep this user manual in a safe place
for future reference. This user manual
belongs with this product. Make sure to
include this user manual when passing the
product on to third parties.
Explanation of the symbols
2.2.
The following symbols are used in the user
manual or on the product:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Denotes risk of personal injury, loss
of life or damage to the tool in case
of non-observance of the
instructions in this manual.
Risk of electric shock.
Only operate the spindle lock in idle
mode.
Do not reach into the saw blade.
Caution: laser beam! Do not look
into the laser beam.
LASERSTRAHLUNG
NICHT IN DEN STRAHL BLICKEN
LASER KLASSE 2
LASERSTRALING
KIJK NIET IN DE STRAAL
LASER KLASSE 2
The product is not suitable for wet
grinding.
The product is not suitable for
rough grinding.
Switch the product off, pull the
mains plug to disconnect it from
the mains supply and let the
product cool off before setup,
changing accessories, cleaning,
maintenance, storing and
transporting the product.
Laser information
plate.
04-06-18 11:55