Programming Options - Directed Python 4115P Owner's Manual

remote programming. Do not release the valet button.
4. Press the button on the remote control. The horn honks to confirm the remote
has been programmed.
5. Release the Valet button.
6. Turn the key to the Off position. The horn sounds one long honk to confirm
that remote programming has been exited.
The programming routine exits if any of the following occurs:
• The ignition is turned off
• There is no activity for 30 seconds
• The Valet button is pressed too many times

Programming Options

Feature options will control your system's normal operation. Some op-
tions may require additional parts and installation labor. The following
is a list of the programmable options with the factory settings in bold.
12 minute to 60 minute runtime. Your system can be programmed
•
to allow the vehicle to run for up to 60 minutes when remote
started. This can be set up to minute increments by your installer.
Parking lights flashing or constant. Your system can be programmed
•
to flash the parking lights or have them come on constantly during
the remote start operation.
Ignition switch controlled door locking ON or OFF. With this fea-
•
ture on, the doors will lock 3 seconds after the ignition key is
turned on, and will unlock when the ignition key is turned off.
Important: The door lock option must be installed for the ignition con-
trolled door lock feature to work.
© 2015 Directed. All rights reserved.
7