Advertisement
ASSEMBLY INSTRUCTIONS CONTINUED
1.
Assemble the Front &
Rear Stabilizer (#117,
127) with Bolt (#122),
Washers (#136, 137)
and Acorn Nut (#125).
2.
Connect the upper
Control Wire to the
lower one. Push up
the Upper Front
Cover (#68) along
the Upright & Rocker
(#2) lift the Upright &
Rocker and insert it
into the Frame(#1).
Insert Bolt (#69),
Washer (#70, 77),
leave them finger
tight until all are in
place, and then
tighten them with the
Lug Wrench. Slip the
Upper Front Cover
(#68) down and snap
into place.
BladeZ Corporation • 20155 Ellipse • Foothill Ranch • CA • 92610
www.ebladez.com
7
• Phone 949-206-8152 • Fax 949-206-0013
Hide quick links:
Advertisement
