Epson ColorWorks C6500Au Technical Reference Manual page 218

Roll Die-cut Label (without Black Mark)
Waste part
Form
Backing paper width
Label width
Label length
Gap between Labels
Waste part on the left and right
Label corner R
Paper thickness
Roll paper core inner diameter
Roll paper outer diameter
Winding direction
*1: If the gap is 3 mm or less, you need to adjust the detector.
• Paper with holes or cutouts cannot be used.
• Set the cut position to a position at least 0.7 mm away from the black mark of the next label.
Backing paper width
Label width
Roll paper
25.4 to 215.9 mm
21.4 to 211.9 mm
When auto cut is not used: 8 to 609.6 mm (up to 24 inches)
When auto cut is used: 15 to 609.6 mm (up to 24 inches)
2 to 6 mm* 1
2 ± 0.5 mm
1.5 mm or more
Matte Paper: 0.178 mm
Synthetic: 0.229 mm
Glossy Paper: 0.174 mm
Glossy Film: 0.164mm
High Glossy Paper: 0.188mm
76.2 mm ±0.5 mm
152.4 mm or less
Print side must be facing outside (facing inside is unusable)
Paper feed direction
Cut position
Side edge baseline
Waste part
Backing paper
Label area
Appendix
218