Never use steam cleaners.
Before cleaning, ensure that the cooking zones are switched off and that the residual heat
indicator ("H") is not displayed.
IMPORTANT: do not use abrasive sponges or pan scourers as they could ruin the glass surface.
After each use, clean the hob once it has cooled in order to remove any food residues.
Sugar and foods with a high sugar content damage the glass ceramic surface and must be
Salt, sugar and sand can scratch the glass surface.
Use a soft cloth, absorbent kitchen wipes or a specialist hob cleaner (see the manufacturer's
Read and follow the instructions given in the section "Instructions for use".
Connect the hob to the electricity supply and check that the supply has not been shut off.
Clean the hob and dry it thoroughly.
If you are unable to turn the hob off after using it, disconnect it from the power supply.
If alphanumeric codes appear on the display when the hob is switched on, consult the following table
The hob switches off,
and after 30 seconds
emits an acoustic
C81, C82, C83
F42 or F43
F12, F21, F25, F36, F37,
F40, F47, F56, F58, F60,
F61, F62, F63, F64
on control panel area.
The control panel
switches off because of
voltage is wrong.
Call the After-Sales Service and specify the error code.
Water or utensils on
electronic parts is too
The sensor detects a
the appliance voltage
and that of the mains
Clean the control
Wait for the hob to cool
down before using it
Disconnect the hob
from the mains and
check the electrical