Automatic Icemaker - GE PVD Series Owner's Manual & Installation Instructions

Automatic Icemaker

A newly installed refrigerator may take 12 to 24 hours to begin making ice.
Connect to potable water supply
WARNING
only.
A cold water supply is required for automatic icemaker
operation. The water pressure must be between 40
and 120 psi (275-827 kilopascals).
Automatic Ice maker
The ice maker will produce seven cubes per cycle
approximately 100–130 cubes in a 24-hour period,
temperature, number of door openings and other use
conditions.
(-10°C). A newly installed refrigerator may take 12 to 24
hours to begin making ice cubes.
If the refrigerator is operated before the water line
connection is made to the unit or if the water supply to
an operating refrigerator is turned off, make sure that
the ice maker is turned off. Once the water has been
connected to the refrigerator, the ice maker may be
turned on. See the table below for details.
fills with water.
To fill the bucket to maximum capacity after installation,
dispense 3-4 cubes at 12 hours and 18 hours. Allow 2-3
days for the bucket to completely fill with ice.
Ice Bucket and Dispenser
• Open the ice box door on inside
of the left door.
• Pull up and out on the ice bucket
in the left hand door to remove it
from the compartment .
• To replace the ice bucket, set it
on the guide brackets and push
until the ice bucket seats properly.
• If bucket cannot be replaced, rotate the ice bucket fork
18
Throw away the first few
batches of ice to allow
the water line to clear.
Be sure nothing interferes
with the sweep of the
feeler arm.
When the bin fills to the
level of the feeler arm,
the ice maker will stop producing ice. It is normal for
several cubes to be joined together.
If ice is not used frequently, old ice cubes will become
cloudy, taste stale and shrink.
NOTE: In homes with lower-than-average water
pressure, you may hear the ice maker cycle multiple
times when making one batch of ice.
CAUTION
avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases
automatic ice making mechanism while the refrigerator is
plugged in.
To turn the icemaker ON/OFF, use the Settings button
to navicate to the Icemaker selections. See CONTROLS,
page 9.
49-1000332 Rev. 0