Quax HIP 05 05 31 Series Handling Manual page 17

HIP
05 05 31xx
4. Assembly of the changing table
Step 1 : Use both crossbars B, four wooden dowels M, the four legs A, both shelves C, four eccentrics H,
four connectors K, eight cylindrical nuts J and eight bolts G
Push two wooden dowels (M) in the lower drillings on the ends of both crossbars (B). Push two eccentrics
(H) into the drillings on the inside of the crossbars. Tighten a connector (K) into the hole on the inside of
each leg (A). Push the crossbars with their wooden dowel into the drilling and over the connector of two
legs. Push the other legs with their connector into the drilling and over the wooden dowel of cross bars.
Tighten the eccentrics. Push eight cylindrical nuts (J) into the drillings at the bottom of the shelves. Insert
the shelves between the legs. Push the bolts (G) into the holes provided on the front of the legs and tighten
into the nuts.
Step 2 : Use the top D, four bolts I, four cylindrical nuts J, the back F, both barriers E, six wood screws L
and the chassis of step 1.
Place the back (F) with its drillings on top of the holes at the back of the top (D). Push two wood screws
(L) in the drillings below the top and tighten in the back. Repeat this action with both barriers (E) and four
wood screws. Push a cylindrical nut (J) in the drilling on top of each leg (A). Position the mounted diaper
unit with its drillings in front of the holes on top of the legs. Push the bolts (I) into the holes on the upperside
of the top and tighten into the nuts.
Luiertafel
Wickeltisch
Table à langer
Diaper table
Quax Quax
® ®
First dreams First dreams
First steps First steps
17