Black & Decker BDLB28-XJ Quick Start Manual page 4

ENGLISH
battery(s). Inserting batteries into
power tools and appliances that have
the switch on invites accidents.
Under abusive conditions, liquid
may be ejected from the battery,
avoid contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
Carefully follow all instructions and
warnings on the battery label and
package.
Always insert batteries correctly with
regard to polarity (+ and -), marked on
the battery and the equipment.
Do not short battery terminals.
Do not charge batteries.
Do not mix old and new batteries.
Replace all of them at the same time
with new batteries of the same brand
and type.
Keep batteries out of the reach of
children.
Remove batteries if the device will not
be used for several months.
Never attempt to open for any reason.
Do not store in locations where the
temperature may exceed 40 °C.
When disposing of batteries, follow the
instructions given in the section
"Protecting the environment".
Do not incinerate the batteries.
Features
This appliance includes some or all of the
following features:
1. Hook
2. LED light bar
3. On/off/ button (BDLB14)
4. Battery compartment
5. On/off button (BDLB28)
Assembly
Installing the batteries (fig. A)
Warning! Use AA size batteries only. Use
alkaline batteries only.
Turn the light bar upside down to get
access to the battery compartment
cover (4).
4
Unscrew the battery compartment
cover (4) anti-clockwise and remove it.
Insert three new alkaline AA batteries
(5), make sure to match the (+) positive
and the (-) negative terminals correctly.
Locate the cover (4) into the base of
the light bar. It will only fit one way, do
not force it.
Screw the cover (4) of the battery
compartment clockwise to lock it into
position.
Use
Using the hook (fig. B and C)
The hook (1) may be used to store or
suspend the light bar. The hook rotates
so that the light bar (2) can be set to
any position. Make sure that the hook
is secure around the supporting object.
Operating the 360 light bar (BDLB28)
(fig. B)
Press the on/off button (3) once for
torch (focused beam).
Press the on/off button (3) again to
illuminate area light.
Press the on/off button (3) again to
illuminate the lantern.
To turn the unit off, press the on/off
button (3) again.
Operating the mini light bar (BDLB14)
(fig. C)
Press the on/off button (5) once to
illuminate six of the LED's.
Press the on/off button (5) again to
illuminate all of the LED's.
To turn the unit off, press the on/off
button (5) again.
Maintenance
Your Black & Decker tool has been
designed to operate over a long period of
time with a minimum of maintenance.
Continuous satisfactory operation
depends upon proper tool care and
regular cleaning.
Warning! Before performing any
maintenance or cleaning of the tool, unplug
the unit from the power supply.