7 FAUCET BODY INSTALLATION
Insert the faucet Pull-out Hose (7A) through the center hole of the sink. Insert Valve
Shanks (7B) through the end holes of the sink.
8 SECURING FAUCET BODY
From underneath sink, place Square Washers (8A) onto Spout Shank (8B) and Valve
Shanks (8C). Tighten Locknuts (8D) by using Installation Tool (8E). For better leverage,
use a Screwdriver (8F), insert it through Hole (8G) and tighten the Locknuts (8D) until
Faucet Body (8H) is ﬁrmly secured to sink.
9 HOSE CONNECTION TO VALVE BODY
Slide the End Connectors (9A) with arrow (9D) pointing up onto the Valve Bodies (9B).
Push the End Connectors (9A) all the way up until completely seated. Be careful not
to damage O-Rings (9C).
Reverse steps to remove Hose Connection.
10 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (10A) into Water Supply Lines (10B). Then, insert Inlet
Connectors (10A) into Valve Bodies (10C). Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (Supply lines not included). Please follow
manufacturer's instructions when installing supply lines. Next, insert Clips (10D) into
Valve Body Holes (10E), to secure unit.
WARNING: Do not twist Inlet Connectors (10A) once installed!
Reverse steps to remove.