GE Profile Series Owner's Manual page 8

Getting started
Select Options
5
The light by the selected button will be lit to indicate which Option has been selected.
Normal This option is for normally soiled dishes, optimizes wash performance while conserving energy.
Temp
Boost This option increases the temperature to help clean heavily soiled dishes and will increase the
cycle time by 20 to 50 minutes. Option may be turned On or Off during the wash cycle. This
option will also improve dry performance on the Normal cycle.
Steam-Sani, This option raises the water temperature in the final rinse to sanitize your dishware but may
Presoak- increase cycle time by 60 minutes. The cycle length will vary depending on the temperature of
Sani, or your inlet water.
Sanitize NOTE: This option is monitored for sanitization requirements. If the cycle is interrupted during
or after the main wash portion or if the incoming water temperature is so low that adequate
water heating cannot be achieved, the sanitizing conditions may not be met. In these cases,
the Sanitized or Cycle Sanitized light will not illuminate at the end of the cycle. Utilizing this
option will modify the cycle to meet the requirements of Section 6, NSF 184 for soil removal and
sanitization efficacy.
NOTE: NSF certified residential dishwashers are not intended for licensed food establishments.
Dry Boost Shuts off the drying option. Dishes air dry naturally and energy is saved. Open the dishwasher
Off door to speed drying.
Dry Boost Turns on the option for faster drying. This option may add up to 64 minutes to the cycle time.
Normal On models with the hidden heater feature, this option boosts the temperature of the dishwasher
during the final rinse portion of the cycle then utilizes a fan to circulate air to dry the dishes. This
very efficient fan may run for an additional 90 minutes after the cycle is complete to maximize
drying performance. Fan operation will end if the door is opened during this 90 minute period.
This option is not available with the Rinse cycle.
Dry Boost This option can be selected by pressing the Dry Boost pad twice to illuminate the High light. It
High (on will add additional time to your drying option, further enhancing the dishwasher's performance
some for difficult to dry items.
models)
Wash Selecting either the Upper or Lower Wash Zones will target dishwashing of just one rack. This
Zones will shorten the cycle time and conserve energy. This option should be used when dishes are
(on some placed in only one rack.
models)
Bottle Jets This option increases the time that the bottle jets are on and may add up to 23 minutes to the
(on some cycle time. Use this to wash difficult to clean, dishwasher safe baby bottles, sport bottles, tall
models) coffee cups, etc. See use recommendations in the
Delay Delays the start of a wash cycle up to 8 to 12 hours depending on model. Press Delay Hours,
Hours to select the number of hours, then press Start one time and close door to begin countdown.
The cycle will start once allotted time has expired.
Lock You can lock the controls to prevent selections from being made. You can also lock the
Controls controls after you have started a cycle to prevent cycle changes. For example, children cannot
accidentally start the dishwasher by pressing buttons with this option selected.
To LOCK/UNLOCK the dishwasher control, depending on the model, press and hold the Dry
Boost pad, or the Steam-Sani/Presoak-Sani/Sanitize pads at the same time, for 3 seconds.
The Lock Controls light will turn on to indicate the control is locked and will turn off to indicate
the control is unlocked.
8
Loading section.
49-4000214 Rev 0