Maintenance And Inspection - Hitachi FCH 48Y Handling Instructions Manual

2. Cutting bushes
Apply the blade to the bush in swift movements to
obtain fine cutting.
3. Shaping bushes
Move the tool from the bottom to the top to shape
thick foliage to your preference.

MAINTENANCE AND INSPECTION

CAUTION: Be sure to switch the power OFF and
disconnect the plug during maintenance and
inspection.
1. Lubricating the blade
After use, clean the blade with a brush and cloth and
apply machine oil with low viscosity to both sides of
the blade (Fig. 8).
In order to prevent injuries caused by the blades
when not in use, the sharpened cutting blade should
be covered by the blunt cover (Fig. 5).
2. Inspecting the mounting screws:
Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.
3. Servicing
Consult an authorized Service Agent in the event of
power tool failure.
NOTE:
Due to HITACHI's continuing program of research and
development, the specifications herein are subject to
change without prior notice.
Information concerning airborne noise and vibration
The measured values were determined according to
DIN45635, DIN45675.
The typical A-weighted sound pressure level: 93 dB (A).
The typical A-weighted sound power level: 99 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value: 7.0 m/s .
2
English
15