Table of Contents
Advertisement
Part Description
Information of slide switch
CVT TYPE
Room Temp. Sensing
Remo .
Indoor Unit
2TH(Remo+Indoor)
Ceiling Height
Low
Standard
High
Single
Group
When using Synchro operation, you must select "single" of group control switch.
6 Weekly Wired Remote Controller
Room Temperature Sensing select
Switch
1. Use Remocon's sensor
2. Use Indoor's sensor
3. Use senor which has lower temrerature
between Remocon's and indoor's
Ceiling Height select switch
1. Low
2. Standard
3. High
Group control select switch
1. Case of Single control
2. Case of Group control
Installation instruction
1
Remove the sticker that is attached on back of insulation and
attach the remote control on the wall you want to install.
2
Separate the cover of remote control like the right hand side.
3
Fix the setup board on top of the insulation.
insulation
remote control
lock screw
4
Install each remote control with the distance of at least 2cm
between them when installing several wired remote controls
horizontally.
CAUTION
Before installing the wired remote controller, set the switch on the back of the wired remote controller
to the required condition of the product.
Especially, if the switch exclusively for air conditioning and air conditioning/heating selection switch is
incorrectly set, it can cause a problem to the product operation.
Installation instruction
wall
2cm
Owner's & Installation Manual 7
Advertisement
Table of Contents
