3. Clean the door with a wet sponge
and rub it dry with a soft cloth. Do
not use steel wool, acids or abrasive
cleaning agents because they can
damage the surface.
When the oven door is clean, install the
glass panels in the opposite sequence.
Make sure that you put the glass panels
(A, B and C) back in the correct
sequence. The glass panel (A) has a
decorative frame. Make sure that after
the installation the surface of the glass
panel frame is not rough when you touch
Refer to Safety chapters.
12.6 Replacing the lamp
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
The back lamp
1. Turn the lamp glass cover to remove
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.