Parts Name; Safety Precautions - Technics SH-1000R Operating Instructions Manual

Turntable base
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12

Parts Name

Position for mounting the SP-10R main unit
 Do not attach insulators here when
mounting the SP-10R main unit.
Doing so may result in noise.
1
Chassis ground*
Insulator

Safety precautions

 Do not put small parts within the reach of small children.
Accidental swallowing of such an item has a harmful effect on the body.
- In the event that such an item has been swallowed, consult a doctor immediately.
 Place this unit on an even surface.
Do not install the product at a high place, uneven place, or place with vibration or impact.
- The product may turn over or fall, resulting in injury.
 Do not put a heavy thing on the product or do not step on the product.
- The product may turn over or fall, resulting in injury.
 Do not place sources of naked flames, such as lighted candles, on this unit.
 Do not install the product in an extremely high temperature.
The outer case and internal parts may be deteriorated.
- Observe the temperature if the product is exposed to direct sunlight or installed near a heater.
 Always use two people or more to install or move the unit.
- Doing so may cause this unit to fall, resulting in personal injury or malfunction of this unit.
 Be careful not to have your fingers caught by the dust cover.
Otherwise your fingers may be injured.
- Particularly keep an eye on a child.
*1 Chassis ground
Position for storing
2
the tonearm base
*
Earth lead
with lug
Basically, there is no need to connect the chassis
ground.
If you are concerned about the noise, connect as
described below. The noise may decrease though it
depends on your environment of use.
*2
Warning
M3 screw
Using a commercially available M3 screw, attach an
earth lead with lug to the chassis ground.
Connect the earth lead to the earth terminal on the
amplifier.
Use a conductive screw.
 The tonearm base that is mounted on the standard position
(
05) for mounting the tonearm base on the SP-10R main
unit can be stored here.
Caution
M3 screw
(Coarse thread)
13 mm or less
12 mm or less
(13)
English
03

Advertisement

Table of Contents
loading

Table of Contents