DAMPP-CHASER Piano Life Saver System Installation Instructions

For grand 7-part system which includes two humidifiers

Hide thumbs Also See for Piano Life Saver System:

Table of Contents

Download this manual

CONTACT YOUR DISTRIBUTOR OR PARTS SUPPLIER

WITH QUESTIONS ABOUT THE SYSTEM.

IMPORTANT INFORMATION

The newly-installed Piano Life Saver System will alter the piano's

wood moisture content and, therefore, alter the tuning. Ideally, the

Dampp-Chaser System should be installed three weeks

BEFORE the piano is tuned.

WARNING: Installation of the Piano Life Saver System must

be made by a professional Piano Technician or Tuner.

Any warranties stated or otherwise implied are void if the

installation is made by someone other than

a professional Piano Technician or Tuner.

Representative for all European countries:

Odd Aanstad

Boda Asen, SE-671 95 Klässbol, Schweden

Tel.: 0046 5705 1184, Fax: 0046 5705 1194 • e-mail: europe@dampp-chaser.com

DAMPP-CHASER CORPORATION

Post Office Box 1610

Hendersonville, North Carolina 28793

828-692-8271 • Fax: 828-692-8272 •e-mail: piano@dampp-chaser.com

www.PianoLifeSaver.com

PN 20399-E 06/06

Table of Contents

Do you have a question about the Piano Life Saver System and is the answer not in the manual?

Page 1 CONTACT YOUR DISTRIBUTOR OR PARTS SUPPLIER WITH QUESTIONS ABOUT THE SYSTEM. IMPORTANT INFORMATION The newly-installed Piano Life Saver System will alter the piano’s wood moisture content and, therefore, alter the tuning. Ideally, the Dampp-Chaser System should be installed three weeks BEFORE the piano is tuned.
Page 2 For GRAND 7-PART SYSTEM which includes TWO HUMIDIFIERS ® INSTALLATION INSTRUCTIONS INSTALLATION TOOLS REQUIRED: You will need the tools listed on the Grand Piano Installation Instructions and also a pair of pliers and scissors. IMPORTANT INFORMATION: These instructions apply only to the connections between the two tanks and to special installation requirements.
Page 3 Install the Humidifier tanks after having read the sections in the grand piano installation instructions referred to on page 1. STEP 1 Make sure the elbow openings are facing each other before putting them into the piano. They were supplied to you so that when installed properly they will be facing each other. If they are not facing each other, move the tanks so that they are.
Page 4 STEP 3 STEP 6 Do not connect the tube to the tanks yet, but route it With the pliers, squeeze open between them so that it stays level. Once you have the the locking rings and move them best level route, mark the tube for cutting, making abso- forward on the tube until they are lutely sure there is enough to go over both elbows.