Husqvarna 120 Mark II Operator's Manual page 10

Hide thumbs Also See for 120 Mark II:
Table of Contents

Advertisement

2. Remove the bar nuts and the sprocket cover.
Remove the transportation guard (A).
3. Put the guide bar above the bar bolts. Steer the
guide bar to its most rear position.
4. Put on protective chainsaw gloves.
10
5. Lift the saw chain above the drive sprocket and
engage it in the groove on the guide bar. Start on the
top edge of the guide bar.
A
6. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
7. Assemble the sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
8. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket. Also make sure that
the saw chain is correctly engaged in the groove in
the guide bar.
9. Tighten the guide bar nuts with your fingers.
657 - 006 -

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents