Download Print this page

Maintenance And Care; Troubleshooting Tips - Black & Decker Price Pfister Portland R89-5 Series Manual

Tub only trim kit
Hide thumbs

Advertisement

MAINTENANCE & CARE
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Price
Pfi ster Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative fi nishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
TROUBLE SHOOTING TIPS
C
B
Temperature or fl ow does not remain consistent.
The Cartridge Assembly (D) may need cleaning. Shut off water supply. Unscrew
Retainer Sleeve (B) and remove Flange (C). Remove Cartridge assembly
(D) and inspect Cartridge (E) and inlets for debris or sediment and fl ush with
E
E) and inlets for debris or sediment and fl ush with
water. Reassemble whole unit and test. If problem persists you may need to
replace the Cartridge (E). E). E
J
F
E
D
G
ENGLISH
Sleeve (B) is too short.
Extension kit 910-563 is available at a nominal charge for valves which have
been roughed-in too far back in the wall. The kit contains a one inch stem
extension, and longer screw and a sleeve which is one inch longer than the
972-300.
Dripping from the tub spout.
Clean the Cartridge Assembly (D). Check to ensure the two Oval O-Rings (F) F) F
on the back of the Cartridge (E) are in place. Reassemble cartridge, stem and
bonnet assembly and handle. Turn on the water and test. If the unit still leaks,
replace the Cartridge (E). E). E
Make sure that both hot and cold water inlets are turned on.
Water fl ow is very low.
Check the Cartridge Assembly (D), for debris. Sediment where the water enters
the Tub Spout (H) can also cause this symptom.
Water starts out hot and becomes cooler as handle is rotated counter
clockwise.
This is a potentially hazardous situation and should be corrected before using
the unit. Check the hot and cold inlet positions (hot- left cold-right). If you have
a back to back installation, (where hot and cold inlets are reversed) refer to
Valve Body instruction sheets for back to back installation.
Water doesn't get hot enough.
Remove Sleeve (B) and Flange (C) and then refer to Valve Body instruction
sheets for adjusting temperature range.
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfi ster.com
• Installation Support
• Care and Warranty Information
4
E
E) are in place. Reassemble cartridge, stem and

Advertisement

loading

  Related Manuals for Black & Decker Price Pfister Portland R89-5 Series