Timex 555-095000 User Manual

THANK YOU FOR PURCHASING YOUR TIMEX WATCH.
EXTENDED WARRANTY
Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase
for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-448-4639 during
normal business hours. Payment must be made within 30 days of purchase. Name, address,
telephone number, purchase date, and 5-digit model number required. You can also mail a
check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR 72203.
Please read instructions carefully to understand how to operate your Timex watch.
Your model may not have all of the features described in this booklet.
Time and date (12/24-hour format) • Hourly chime • Daily alarm • 24-hour chronograph •
INDIGLO® night-light
MODE
1. Press MODE until Time display appears.
2. Press SET. Seconds will flash. Press START/STOP to set to 00.
3. Press MODE. Second digit of minutes will flash. Press START/STOP to advance.
4. Press MODE. First digit of minutes will flash. Press START/STOP to advance.
5. Press MODE. Hour (with A/P) will flash. Press START/STOP to advance. Press SPLIT/RESET to
switch between 12- and 24-hour format.
6. Press MODE to continue setting month, date, day of week.
7. Press SET to exit at any time.
In Time display, press START/STOP to turn hourly chime on/off. Colon will flash when on.
1. Press MODE until "ALARM" appears in upper left of display. Alarm time appears at top of display.
2. Press SET. Hour will flash. Press START/STOP to advance.
3. Press MODE. First digit of minutes will flash. Press START/STOP to advance.
4. Press MODE. Second digit of minutes will flash. Press START/STOP to advance.
5. Press SET to exit at any time. Alarm is automatically armed.
When alarm is armed,
In Alarm mode, press START/STOP to arm/disarm alarm.
When alarm sounds, press any button to silence. Alarm remains armed and will continue to
occur daily.
MINUTES
1. Press MODE until "CHR" appears.
2. Press START/STOP to start chrono.
3. Press START/STOP to stop. Press again to continue.
4. When chrono is stopped, press SPLIT/RESET to reset chrono to zero.
Taking Splits
While the chrono is running, you may freeze the display, to see your time at a particular point.
This is called "taking a split." To take a split, press SPLIT/RESET while the chrono is running.
"SPLIT" appears and the display will freeze for ten seconds before showing the running chrono
again. You may skip the ten-second freeze by pressing MODE.
If you exit Chrono mode with the chrono running, it will continue to run. In the Time display,
"CHR" will flash.
Press INDIGLO (SPLIT/RESET) when time of day or alarm time is displayed (but not while setting)
to activate night-light. Electroluminescent technol-
ogy used in INDIGLO® night-light illuminates entire watch face at night and in low-light condi-
tions. Release INDIGLO to turn light off.
If your watch is water-resistant, meter marking or (
Water-Resistance Depth
30m/98ft
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.
1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
Timex strongly recommends that a retailer or jeweler replace battery. If applicable, push
reset button when replacing battery. Battery type is indicated on caseback. Battery life esti-
mates are based on certain assumptions regarding usage; battery life may vary depending on
actual usage.
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP LOOSE BATTERIES
AWAY FROM CHILDREN.
www.timex.com
W-116
BASIC OPERATIONS
SET
SET TIME-DATE
appears here and in Time display.
CHRONOGRAPH
INDIGLO® NIGHT-LIGHT
WATER RESISTANCE
555-095000
FEATURES
ALARM
) is indicated.
p.s.i.a.* Water Pressure Below Surface
BATTERY
START/STOP
SPLIT/RESET
or INDIGLO
HOURS
1/100 SECONDS
SECONDS
60
(warranty information on reverse)