Adjustments; Operating Instructions - Sealey Ts10Cz Instructions

5.5. Changing the blade
5.6. Fence
5.7. Table insert
F WARNING!

6. OPERATING INSTRUCTIONS

WARNING! As with all power tools, there are potential hazards
involved in the use of this saw. It is, therefore, vital to ensure you
have read and understood all the safety instructions in Section 1.
Familiarise yourself again with the specific saw safety rules for
each step of the following operation. Failure to do so could cause
serious damage and/or personal injury and may invalidate your warranty. Disconnect the saw from the mains power before making any
adjustments or removing/fitting the blade. Ensure that all screws and nuts are secure and that the blade is in good condition and correctly
fitted. ALWAYS position the blade guard as close as possible to the workpiece before turning on the saw. Wear approved safety eye protection.
Note: Figs. 6, 7 & 8 are for illustration purposes and may not reflect exactly the detail of your saw.
6.1. Cross cutting
I CAUTION! If you are bevel cross cutting ( i.e. blade is tilted) use the
right-hand slot only. This will ensure that the blade is tilted away
from the cross stop and your hands
F WARNING! DO NOT attempt to pick up an off-cut before the saw blade has completely stopped.
F WARNING! DO NOT use the fence as a cut-off gauge when cross-cutting.
6.2. Rip sawing
F WARNING! The safety precautions stated at the beginning of this section must be adhered to.
6.2.5. Ripping a workpiece more than 120mm wide
fig. 4
fig.6
fig. 5
fig. 7