Carpet Cleaning; Hard Floor Cleaning - Bissell QuickSteamer 1770 Series User Manual

O
peration

Carpet cleaning

1.
With your foot, press the red power switch
[located in foot of unit] ON.
2.
With foot, press the detent lever on right side of
lower body.
3.
Depress spray trigger to spray cleaning solution.
Do not overwet.
4.
To suction up water, repeat motion over same
area without pressing trigger.
5.
Repeat steps 3 and 4 until no more dirt can
be removed.
6.
Continue to clean entire carpet, working in
3' x 4' sections.
7.
Empty the collection tank when dirty water reaches
the full line, or when the solution tank is empty. See
page 8 for instructions.
8.
If floor nozzle stops spraying, turn power switch
OFF and check water and cleaning solution levels.
Refill if needed.

Hard floor cleaning

1.
Attach hard floor tool to unit.
2.
Remove the collection tank (refer to steps 3a and b
in the Maintenance and care section on page 8)
a. For 1770/1970 series it is necessary to
remove the cross action brush first.
Using your thumbs squeeze the 2 grey tabs
towards the outside of the unit. Push down
at the same time and release the cross
action brush.
3.
Attach the hard floor tool by hooking it into the
front of the removable nozzle and swinging it
down until the tabs pop into place.
4.
Replace the collection tank. Be sure to attach the
2 latches.
5.
Fill solution tank with BISSELL Hard Floor
Solutions™ to FORMULA fill line.
6.
Fill solution tank with hot (not boiling) tap water to
the WATER fill line.
7.
Follow steps 1-8 in Carpet cleaning section above.
w w w . b i s s e l l . c a
Tip:
It is recommended
that every time your
solution tank needs
refilling, that you empty
the contents of the
collection tank. If the
collection tank gets too
full, you may begin to
see foam spitting out
of the vent cover. If this
happens empty the
collection tank.
3.
2080/2090 series
OR
3.
1770/1790 series
7
8 0 0 . 2 6 3 . 2 5 3 5