Table of Contents
Advertisement
Available languages
Available languages
Safety system
Q
Note: the heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off
automatically due to a fault, then the function
indicator
on the control unit
2
minate, even if the heating pad is switched on.
j
P lease note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Operation
Q
Note: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
j
P lace the heating pad in position as shown in
Fig. C. Join the two ends of the heating pad
together.
j
I ntegrated magnets
ends of the heating pad remain in contact.
j
Y ou can use the snap fasteners
a closer fit.
Switching on / off / Selecting
Q
the temperature
j
T o begin, first connect the control
heating pad with the plug-in connector
(see Fig. B).
Switching on:
j
S et Level 1, 2, 3, 4, 5 or 6 on the control
switch the heating pad on.
Note: The function indicator
the heating pad is switched on.
Note: this heating pad features rapid heating,
which allows it to heat up within the first 10 minutes
of operation.
64641_silv_Schulterheizkissen_Content_LB3.indd 9
Safety system / Operation / Cleaning and care
ceases to illu-
1
ensure that the two
4
if you wish
5
to the
1
3
to
1
illuminates after
2
Switching off:
j
S et Level 0 on the control
heating pad off.
Note: The function indicator
Selecting the temperature:
j
J ust before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
j
I f you are going to use the heating pad for a
number of hours, set it to the lowest temperature
setting (setting 1).
Temperature levels
Q
j
S et the required temperature level on the
control
(see Fig. A).
1
Level 0:
off
Level 1:
minimum heat
Level 2-5: customised settings
Level 6:
maximum heat
Automatic switch-off
Q
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function indicator
then starts to flash.
j
T hen select the setting 0 and after about
5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
j
S witch the heating pad off (setting 0) and
pull the mains plug out of the mains socket if
the heating pad is not to be used after it has
switched itself off automatically.
Cleaning and care
Q
J
WARNING!
LIFE BY ELECTRIC SHOCK! Al-
ways remove the mains plug from
the socket and the plug-in connector
the control
from the heating pad (see Fig. B)
1
before cleaning the heating pad.
to switch the
1
ceases to illuminate.
2
DANGER TO
with
3
GB/IE
9
07.04.11 09:28
Advertisement
Chapters
Table of Contents
