Chamberlain TRICODE Quick Start Manual
Chamberlain TRICODE Quick Start Manual

Chamberlain TRICODE Quick Start Manual

Tcr1 single channel receiver

Advertisement

WARNING

SPECIFICATIONS

CAUTION
Output Rating: 5 Amps 28Vac/Vdc Max.
Power: 12Vdc or 18 to 34Vac/Vdc, @ 30ma
RF Frequency: 300 or 310 MHz
Accessory Transmitters: TC1, TC2 and TC4
The TriCode
®
digital receivers are designed for use with automatic
garage/gate operators and access control systems. All TriCode
products may be matched with Linear/Delta-3
Stanley
TM
radio products which may already be installed.
The TriCode
®
radio format provides a potential of 1024 different
digital codes. For Linear/Delta-3
different digital codes are available. The codes are set using
10-position DIP switch system.
TM
, Multi-Code
TM
compatible products 256
U.S. Patent 6,915,146
TRICODE
®
To prevent possible SERIOUS INJURY or DEATH from electrocution:
• Be sure power is NOT connected BEFORE installing the receiver.
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
• ALWAYS keep transmitters out of reach of children. NEVER permit
children to operate or play with remote control transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
®
• ALWAYS keep gate or garage door in sight until completely closed.
TM
and
NEVER permit anyone to cross path of moving gate or door.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
®
TCR1 SINGLE
CHANNEL RECEIVER
USED FOR TCR1 AND TCR2
WARNING
WARNING

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRICODE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Chamberlain TRICODE

  • Page 1: Specifications

    ® digital receivers are designed for use with automatic adjusted, and there are no obstructions to door travel. garage/gate operators and access control systems. All TriCode ® • ALWAYS keep gate or garage door in sight until completely closed. products may be matched with Linear/Delta-3 , Multi-Code NEVER permit anyone to cross path of moving gate or door.
  • Page 2 NOTE: To avoid the possibility of duplicating codes in adjacent Power Supply Selection Setting systems, all transmitters and receivers should be re-coded prior The TriCode ® receiver is factory set for 24 volt power input if to operation. Unless using maximum number of codes the 12 volt is required.
  • Page 3 OUTPUT RELAYS, CONFIGURATION & DIP SWITCH SETTINGS Setting Output Relay Mode Setting DIP Switch The TriCode ® receiver is factory set for momentary relay output The TriCode ® receiver DIP switch CH1 is factory set OFF (1-10) “MNT”. and CH2 is factory set ON (1-10).
  • Page 4 If spacing is different or not marked, use the wiring diagram in Figure 5. For installation and service information please call our toll free number: 1-800-528-2806 or contact us through the web at www.chamberlaingroup.com © 2007, The Chamberlain Group, Inc. 01-16700D All Rights Reserved...

Table of Contents