SwanStone BS-2515 Owner's Manual

TOOLS REQUIRED

• Ruler
• Drill
• Caulk
• Saber Saw
(if counter top
cutout is required)
BS-2515
TRACE COMPLETELY
AROUND EDGE OF SINK
1. If it is necessary to cut out
the counter top, invert sink
and position onto the counter
top. Locate sink front to rear
and so that the bowl will not
interfere with the cabinets
below. Trace a pencil line
around the outside edge of
the sink and remove the sink
from the counter top.
OWNER'S MANUAL
MODEL NOS.
BS-1515
BS-2515
BS-1515
DRAW A 1-1/2 RADIUS
AT EACH CORNER
5/16
2. Measure in 5/16 from the
initial sink outline and draw a
second line inside the first.
Draw a 1-1/2 radius at each
corner. This second interior
line will be your cutout line.
Check Cutout
Line Measurements
Model Width Depth
BS-1515 14-3/8 14-3/8
BS-2515 24-3/8 14-3/8
Measure the cutout or the
pre-cut opening to be sure it
conforms to the sizes listed.

Installation

CAUTION:
Read
Care and
Cleaning
Save this manual for future reference.
BAR SINKS
DRILL STARTER HOLE
INSIDE OF CUTOUT LINE
CUTOUT LINE
3. Drill starter hole inside of
cutout line.
instructions carefully
starting your installation.
CUT INSIDE OF LINE
4. Using a saber saw, cut
inside of cutout line. Trial fit
sink to check proper fit.