Led Lighting - ubbink MAMBA Series Operating Instructions Manual

Stainless steel waterfalls
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 11
1 Operating Instruction for Stainless Steel Waterfalls MAMBA / MAMBA LED / BIRDIE LED
Extraordinary designer waterfall made of chlorine and salt water resistant stainless steel for swimming pools and garden ponds. Including accessories for connecting to
Extraordinary designer waterfall made of chlorine and salt water resistant stainless steel for swimming pools and garden ponds. Including accessories for connecting to
existing pool lter systems and garden pond pump. The model COBRA LED/BIRDIE LED with integrated LED-lighting (12V).
existing pool lter systems and garden pond pump. The model MAMBA LED/BIRDIE LED with integrated LED-lighting (12V).
Technical data
Model
Article number EU
Material
Hose connection
Recommended pump capacity
Pools with sand lter
(0.8 bar = 8 m delivery head)
Garden ponds
LED-lighting
LED-strip
Voltage/frequency
Safety transformer
Power consumption
Cable length LED-lighting
Class of protection
Protective system
Delivery volume
Tee-piece connector 1 1/2 "
Ball valve 1 1/2"
Hose nipple 1 1/2" x 38 mm
Hose clip 25-40 mm
Hose 38 mm
Base plate
Screws and nuts
Safety transformer
Please read this operating instruction thoroughly before you start the waterfall MAMBA or MAMBA LED/BIRDIE LED.
Safety instructions
Safety instructions
• The power supply of pump and LED-lighting must meet the product speci cations. Do not connect the pump, LED-lighting and power supply cable, if the power supply does not
meet the speci ed regulations! Further information can be obtained from your local approved electrical installation specialist.
The plug connection of the pump and LED-lighting must be more than 3.5 m away from the swimming pool or garden pond.
• The power supply of the pump and LED-lighting must be via a safety transformer or earth leakage circuit breaker (FI-switch) with a rated fault current ≤ 30 mA. Always use a
safety transformer IP X4 for the LED-lighting in outside areas.
• The power supply cable of the LED-lighting cannot be replaced. The device cannot be used any more if the cable is damaged and must be disposed properly.
The power supply must always be disconnected during assembly or disassembly and maintenance of the pump and LED-lighting.
The devices are not suitable for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless these have
been supervised by a person responsible for their safety or have been instructed regarding the use of the device. Children must be supervised in order to ensure that they are not
playing with the devices.
Installation
Installation
Swimming pool with sand lter system
1.) Pool with wood pool edge
• Place the waterfall element at the selected place on the wood pool edge of your swimming pool.
• Ensure that the hose connection for the waterfall element can be connected without problem to the existing water return from the lter to the pool.
• Then prepare the waterfall element for connection with the water return system according to gure 1.
• Use the base plate for marking the drill-holes for the screws, cut-out for hose and LED-lighting cable (MAMBA LED/BIRDIE LED). See gures 2a, 2b and 2c. Pay attention to the
position and wall thickness of the wood construction of your swimming pool.
• You can then rigidly install the waterfall element on the wood pool edge and connect the hose with the supplied screws and nuts. See gures 2d and 2e.
• For MAMBA LED/BIRDIE LED: Check the LED-strip for correct t, install the lighting cable outside the swimming pool and connect it to the safety transformer.
• Check the whole water circuit again for leaks. Leaking screwed or hose connections must be sealed with commercially available Te on-tape.
MAMBA/bridie manual 2012.indd 10
Waterfall MAMBA
7504442
INOX 316 L
1 1/2" (female thread)
5.5 – 11.3/h
Poolmax TP 75 / 120
6,000-12,000 l/h
Cascademax 12000
1
1
4
4
2 m
1
4
-
WATERFALL MAMBA LED/BIRDIE LED
7504459 / 7504666
INOX 316 L
5.5 – 11.3/h
Poolmax TP 75 / 120
6,000-12,000 l/h
Cascademax 12000
30 cm, 20 LED, blue / 30 cm, 20 LED, cool white
12 VAC 50 Hz
TDC 3.25-12 W
2.5 W
5 m
III
IP68
1
1
4
4
2 m
1
4
1
15-12-12 20:45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Birdie led 7504666Mamba led 7504459Mamba 7504442

Table of Contents