7 VALVE BODY ATTACHMENT
Remove Clip (7A) from Valve Body (7B) and save. From above sink, insert
Valve Body (7B) through Mounting Holes (7C). The HOT valve, labeled with
Red Tag (7D), should be positioned to the left side of the spout.
8 VALVE BODY INSTALLATION
From underneath sink, place Mounting Washer (8B) onto Valve Shank (8A)
and tighten with Mounting Nut (8C).
9 SECURING VALVE BODY
From underneath, tighten Mounting Nut (9A) by using Installation Tool (9B).
For better leverage, use a Screwdriver (9C), insert it through Hole (9D) and
tighten the Mounting Nut (9A) until Valve (9E) is fi rmly secured to sink.
10 HOSE CONNECTION TO SPOUT BODY
From underneath sink, insert the Center Connector (10A) onto Spout
Shank (10B), push the Center Connector (10A) up until the top of Socket
(10C) reaches the Spout Shank Stop (10D). Be careful not to damage the
O-Ring Seals (10E). Thread Locknut (
10E). Thread Locknut (
9E) is fi rmly secured to sink.