Stopping - Husqvarna PP518 Operator's Manual

Starting the engine with a weak battery
If the battery is too weak to start the engine, it should be
recharged or replaced.
When jump leads are used for emergency starting, follow the
procedure below:
!
IMPORTANT! Your hydraulic unit is equipped
with a 12-volt system with negative earth.
The other vehicle must have a 12-volt
system with negative earth. Do not use your
unit battery to start other vehicles.
Connecting the jump leads
1 Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
2 Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
3 Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
1 The BLACK cable is removed from the chassis and then
the fully charged battery.
2 Finally the RED cable from both batteries.

Stopping

Turn the ignition key to Stop position to stop the hydraulic unit.
14 –
English
STARTING AND STOPPING