S210
With the S210 base
3
removed, route the cable
between the legs.
S210 S89
7
Retainer Mount
Mount S89B or S89D bracket onto a
suitable mounting surface with the
necessary screws and hardware.
Route the cable through the center
channel of the bracket.
Wiring Block Instructions
®
Lace the cables through the
4
appropriate openings in the
wiring base and snap the S210 wiring
base back onto the legs. Push the
wiring base onto the legs until the
latches "snap" into place. Proceed to
step 9 for terminating instructions.
Note: For additional security, the assembly
can be fastened together using the self-
tapping, Phillips-head screws included.
Lace the cables through the
8
center hole of the S210
™
retainer and snap the retainer onto
the S89 bracket. Proceed to step 9
for terminating instructions.
S210 Wall Mount
1
Mount the S210
and legs onto a suitable mounting
surface with the necessary screws
and hardware.
S210 Rack Mount
5
Mount S210 19 inch panel
onto the rack using the #12-24
screws and washers provided.
S210 Wiring Block
9
89
Strip back only as much cable
jacket as is necessary to terminate
the conductors using the Siemon
AllPrep
Cable Preparation Tool
™
(P/N: CPT-RGTP) or equivalent.
Note: It is not recommended to strip
more than 76mm (3 in.) of cable jacket for
category 5 or higher installations.
Remove the S210 wiring
2
base from the legs by
wiring base
™
depressing the outer 4 fanning strips
of the S210 wiring base inward to
defeat the leg latches. Pull the
wiring base away from the legs.
Note: Legs are detachable on the
64-pair version only.
Lace the cables through the
6
appropriate openings in the
S210 base. Proceed to step 9 for ter-
minating instructions.
Lace the conductors into the
10
S210 wiring base. Pair twist
must be maintained to within 12mm
(.5 in.) of the point of termination for
category 5 or higher installations.
Ample channel space is provided to
allow jacketed cable to continue
close to the point of termination.
Note: The Pyramid
base and block will separate twisted conduc-
tors without special preparations or handling.
™
wire entry system on the