Samsung MIM-H03 User & Installation Manual page 6

How to install Wi-Fi kit
3. Use two or more screws to fix the rear cover of the Wi-Fi kit to a wall. Then, connect the power cable (V1, V2) and the
communication cable(F1, F2) to the terminals on the back of the front cover in appropriate length.
4. When connecting the V1 and V2, tighten the screws for the terminal block (CN5) with a tightening torque of 5 ±2 Kgf·cm.
Size of the screw is M3 x 6.
• Maximum number of indoor unit installation that can be connected to Wi-Fi kit is 16.
• One Wi-Fi kit can be registered with maximum 5 users.
NOTE
- If you register more than 5 users to single Wi-Fi kit, its operation may become slower.
• Each account (one mobile phone) can be registered with maximum 4 Wi-Fi kits.
10 mm
(9/16 inch) or more
10 mm
(9/16 inch) or
more
50 mm (2 inches)
or more
❋ ❋ Before fixing the rear cover, allow
10mm or more space for upper,
left, and right sides and 50mm
space for bottom side.
Item
Ⓐ
Power/communication connection terminal
Ⓑ Tracknig/Initializing button
Ⓒ
SD Card Slot
Ⓓ
LED
Ⓔ
Network PBA
Ⓕ
Interface module PBA
6
10 mm
(9/16 inch) or more
Screw
fixing
hole
Rear cover
❋ ❋ Fix the screws in the
provided screw holes.
Contents
Ⓔ
V1 V2 F1 F2
❋ ❋ Do not tighten the PCB terminal with
too much force.
Indoor unit
Ⓕ
Ⓑ
Wi-Fi kit
Ⓓ
Ⓒ
Ⓐ
PCB
terminal