Panasonic AW-HE130WP Operating Instructions Manual page 16

Stand-alone installation (when the mount bracket is going to be used) (continued)
5.
Check the mounting.
6.
Connect the rear panel connectors.
When three coaxial cables are to be connected, connect coaxial cable [2] first.
Square hole
(one at either side)
Tab (one at either side)
z How to secure the AC adaptor cable
A Loosely secure the cable clamp.
Cable clamp
Loosely secure the cable clamp
in the area shown above.
7.
Attach the cable cover.
• Fit the two tabs on the cable cover into the square mounting hole at either side of the rear panel.
• Secure the cable cover using the screw (M3 x 25 mm) provided.
Screw
Clamping torque
diameter
M3 0.78 N · m (8 kgf · cm)
<NOTE>
• Engage the tabs on the cable cover so they fit into place perfectly, and check that the cover is not rickety.
• When attaching an anti-theft wire, do so after attaching the cable cover.
16
N D
L G
N A
T S I G
O U
2 C
- 2 3
R S
I N
- T X
S E
0 B A
/ 1 0
E - T
A S
1 0 B
2
- 4 2
R S
I D
I R
HDMI cable
Coaxial cable [1]
Coaxial cable [2]
Coaxial cable [3]
RS-232C cable
RS-232C cable
LAN cable
LAN cable
B Fasten the cable clamp.
Strap part
Take hold of the strap part, slide
the cable clamp until it stops
moving, and then secure it tightly.
Screw for cable cover (M3 screw)
(with flat washer, spring washer)
AC adaptor cable