Solid-State Drive Module - HP 280 G4 Maintenance And Service Manual

Solid-state drive module

The M.2 solid-state drive module is located under the drive cage.
For a list of available solid-state drives, see
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the optical drive
4. Remove the front bezel
5. Remove the drive cage
6. Remove the Phillips M2.0 × 3.0 screw (1), and then pull the module out of the socket (2).
To install the solid-state drive module, reverse the removal procedures.
28 Chapter 4 Removal and replacement procedures
Computer major components on page
(Preparation for disassembly on page
(Access panel on page
(Optical drive on page 22).
(Front bezel on page 26).
(Hard drive on page 24).
18).
4.
16).