Page 1
EN Instructions for use / assembly instructions DE Gebrauchsanleitung / Montageanleitung MySport M 1jet 13861003 Ecos M 1jet 14815003 Focus M41 160 1jet 31806003...
English Cleaning (see page 6) Safety Notes Operation (see page 6) Gloves should be worn during installation to prevent crushing and cutting injuries. Hansgrohe recommends not to use as drinking water The hot and cold supplies must be of equal the first half liter of water drawn in the morning or after pressures. a prolonged period of non-use. Installation Instructions • Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured. • The pipes and the fixture must be installed, flushed and tested as per the applicable standards. • The plumbing codes applicable in the respective countries must be observed. Technical Data Operating pressure: max. 1 MPa Recommended operating pressure: 0,1 - 0,5 MPa Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Hot water temperature: max. 70°C Recommended hot water temp.: 65°C Thermal disinfection: max. 70°C / 4 min The product is exclusively designed for drinking water! Symbol description Do not use silicone containing acetic acid! Adjustment (see page 5) To adjust the hot water limiter. Using a hot water limiter...
Deutsch Maße (siehe Seite 7) Sicherheitshinweise Durchflussdiagramm (siehe Seite 7) Bei der Montage müssen zur Vermeidung von Quetsch- und Schnittverletzungen Handschuhe Serviceteile (siehe Seite 8) getragen werden. Große Druckunterschiede zwischen den Kalt- und Reinigung (siehe Seite 6) Warmwasseranschlüssen müssen ausgeglichen Bedienung (siehe Seite 6) werden. Montagehinweise Hansgrohe empfiehlt, morgens oder nach längeren • Vor der Montage muss das Produkt auf Transport- Stagnationszeiten den ersten halben Liter nicht als schäden untersucht werden. Nach dem Einbau Trinkwasser zu verwenden. werden keine Transport- oder Oberflächenschäden anerkannt. • Die Leitungen und die Armatur müssen nach den gültigen Normen montiert, gespült und geprüft werden. • Die in den Ländern jeweils gültigen Installationsricht- linien sind einzuhalten. Technische Daten Betriebsdruck: max. 1 MPa Empfohlener Betriebsdruck: 0,1 - 0,5 MPa Prüfdruck: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Heißwassertemperatur: max. 70°C Empfohlene Heißwassertemperatur:...
Page 4
(3 Nm) 13861003 / 14815003 31806003 SW 23 mm SW 24 mm SW 9 mm SW 10 mm (4 Nm) (4 Nm) SW 22 mm SW 22 mm (2 Nm) > 2 min...
Page 5
60 °C 10 °C 0,3 MPa 36°C 38°C 50°C 60°C 43°C 55°C 17 x...