Table of Contents
Advertisement
9. Remove the recoil spring from the starter pulley.
7.3.3 To assemble the standard starter
1. Pull the starter rope through the hole in the starter
pulley and make a knot. Make sure that the knot is
as small as possible and that it goes into the notch
on the starter pulley.
2. Wind the starter rope 3 turns counterclockwise
around the starter pulley.
16 - Repair instructions
3. Put the recoil spring in the groove of the starter
housing. Push down the recoil spring with your
thumb on the inner side of the starter housing. Move
your thumb around the edge of the starter pulley and
push down the recoil spring turn after turn.
4. Lubricate the recoil spring and the stub axle of the
starter pulley with cold resistant grease or thin oil.
5. Put the starter rope through the opening in the
starter housing.
Hide quick links:
Advertisement
Table of Contents
