LG StudioWorks 520Si Owner's Manual page 38

1. TILT/SWIVEL REMOVAL
1) Set the monitor faces downward.
2) Pressing the latch (a), carefully remove the
Tilt/Swivel by pulling it upward.
2. BACK COVER REMOVAL
1) Remove four screws (a) from the Back Cover.
2) Slide the Back Cover away from the Front
Cabinet of the monitor.
(a)
DISASSEMBLY
3. TOTAL CHASSIS ASSEMBLY REMOVAL
1) Disconnect P902 (Degaussing pin) and P501
2) Remove two screws (a) from the Total
3) Remove the Total Chassis Assembly.
(a)
(a)
4. VIDEO BOARD ASSEMBLY REMOVAL
1) Remove three pins (a).
2) Remove CDT earth connector (b).
3) Carefully separate the Video Board Assembly
4) Discharge the remaining static electricity by
5) Disconnect the Anode Cap from the CDT.
(a)
- 8 -
(DY pin).
Chassis Assembly.
from the CDT neck.
shorting between the Anode Cap and the CDT
ground.
(a)
Anode Cap
Main Bracket
(a)
CDT Assembly
(a)
(b)