Hdtv Projection Monitor - Pioneer SD-533HD Service Manual

QQ
3 7 63 1515 0
5 CH (channel) +, – and 2, 3 buttons
Press plus (+) or minus (–) to tune to a higher or lower channel.
Only the preset channels can be tuned in using these buttons.
Press to select or adjust items on the menu screen.
6 VOL (volume) +, – and 5, ∞ buttons
Press plus (+) button to increase the volume, press minus (–)
button to decrease it.
Press to select or adjust items on the menu screen.
7 MENU button
Press to turn the menu on.
Press again to return to normal TV screen.
8 RETURN button
Press to set the Projection Monitor to its initial mode.
Initial mode
Input selector:
TV channel:
VOLUME:
MUTING:
PICTURE
MODE:
Parameters:
COLOR TEMP:
PURECINEMA:
SVM:
TE
L 13942296513
3D Y/C LEVEL:
3D NR LEVEL:
FLESH TONE:
BLK ENHANCE:
SOUND
MTS:
Parameters:
SURROUND:
STABLE VOLUME: OFF
SCREEN
MODE:
V. POSITION:
CC:
RLS:
•
When this button is pressed while adjusting the MULTI-
POINT convergence, the MULTI-POINT convergence
returns to the initial mode.
9 ROOM LIGHT SENSOR (RLS)
Sensor to detect the room brightness.
0 INPUT 4 jacks
These inputs are for Video Movie and VCR. Use RCA-type pin
plug cords (the same as those used in Hi-Fi systems) and S-
VIDEO cords for connections. When the audio source to be
connected is mono, connect the source to the L-(MONO) jack.
www
.
http://www.xiaoyu163.com
Set to TV.
Remains at the last channel set.
Remains at the last setting.
OFF
STD
Set to 0. (Only contrast +30)
STD
ON
ON
STD
MID
ON
ON
MAIN
Set to 0.
OFF
NATURAL WIDE
NOT USED
OFF
OFF
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
CAUTION:
Do not press any operation button on the Projection Monitor
or the remote control unit while recording. Signals from the
MONITOR OUTPUT jacks may be temporarily interrupted
when a button is pressed.
ATTENTION
The HDTV Projection Monitor will not function properly in the
following cases.
•
An electrical discharge in the CRT.
•
Lightning storms.
•
High static electricity environment.
•
Poor voltage regulation in the power source.
If the Projection Monitor does not operate properly, reset it as
follows:
1. Turn off the power of the unit with the 1 MAIN POWER
button.
2. After approximately 1 minute, turn on the power with 1
MAIN POWER button and 3 STANDBY/ON button.
If the normal operation cannot be restored after the above
treatment, immediately unplug the power cord and call your
nearest PIONEER-authorized service center.
NOTES:
• On rare occasions, an electrical discharge may occur inside the CRT*. It
makes a short, sharp pop and either no sound is produced or the volume
level changes by itself. The SPLIT screen and SEARCH screen functions
Q Q
3 6 7 1 3 1 5
will be cancelled automatically if an electrical discharge occurs when this
function is engaged.
*CRT: Cathode-ray Tube
• When an electrical discharge distorts the screen and the TV power has
been automatically shut off, it can turn on.
If you notice any abnormality of the screen, turn off the MAIN POWER
button for a few minutes then turn it on.
This is not a malfunction.
co
.
SD-533HD5, SD-643HD5
9 4 2 8
0 5 8 2 9 9 4 2 8
m
9 9
9 9
203