Download Print this page

Teleflex Marine 311482-001 Installation Manual

Marine ignition interrupt switch

Advertisement

Quick Links

TELEFLEX MORSE Marine Products
Installation Manual
Page 1 of 4 Pages
Marine Ignition
Interrupt Switch
Part Numbers
311482-001 (For I/0s and Inboards)
311482-002 (For Outboards)
For Use With Teleflex Morse MV3 Side Mounted Controls
This manual must be accessible to the owner/user of this
Teleflex Morse Marine Product
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND THOROUGHLY BEFORE INSTALLING OR OPERATING
THIS IGNITION INTERRUPT SYSTEM! YOU MUST HAVE
THE MV3 SIDE MOUNTED CONTROL INSTRUCTIONS AND
MOUNTING TEMPLATE WITH YOU TO PROPERLY INSTALL
THIS MARINE PRODUCT.
All specifications and features are subject to change without notice.
INSTALLATION, OPERATION and
MAINTENANCE INSTRUCTIONS
055001-695 Rev. C 10/03 © 2003 Teleflex, Inc.

Advertisement

loading
Need help?

Need help?

Do you have a question about the 311482-001 and is the answer not in the manual?

Questions and answers

Summary of Contents for Teleflex Marine 311482-001

  • Page 1 TELEFLEX MORSE Marine Products Marine Ignition Interrupt Switch Part Numbers 311482-001 (For I/0s and Inboards) 311482-002 (For Outboards) For Use With Teleflex Morse MV3 Side Mounted Controls Installation Manual This manual must be accessible to the owner/user of this Teleflex Morse Marine Product...
  • Page 2: General Information

    ë \ General Information This Interrupt Switch is to be used solely with Morse MV3 Side Mounted Controls to stop the engine of an inboard, I/O or outboard powered boat instantly in the event an operator is acciden- tally removed from the controls. The Interrupt Switch includes a lanyard clip which holds the plunger of the Switch in position to allow engine operation.
  • Page 3 6. Reconnect battery. 7. Start engine. If engine does not start: Disconnect battery, recheck all electrical connections, reconnect battery and restart engine. 8. Remove Lanyard. Engine should stop immediately. IF ENGINE FAILS TO STOP, RECHECK ALL WIRING. SHOULD THE ENGINE FAIL TO START OR STOP, OR RESUMES RUNNING WITH THE LANYARD FORK REMOVED, CONSULT YOUR LOCAL...
  • Page 4 8. Attach the other end of the second wire to the ground point, using a suitable insulated wire connection device as shown in Diagram B. 9. Recheck all connections. Install the Lanyard with the Fork Clip seated over the Plunger. 10.

This manual is also suitable for:

311482-002