Line Out/Cd Changer Connections - Sanyo FXC-503LD Operating Instructions Manual

Notes
When using a two-speaker installation, set the FADER control to the center position.
l
When not using a Power AntennalDrternal
l
electrical tape to prevent it from shorting to the unit or vehicle chassis.
When using a two-speaker installation, the Violet, Gray/Black, Green and White/Black wires,
l
which are used for a four-speaker installation, are not used. The ends of these wires must be cov-
ered with electrical tape to prevent them from shorting to the unit or vehicle chassis.
Fus
LINE OUT/CD CHANGER CONNECTIONS(FXC-503LD
Since this unit has a CD changer controller and output terminals, you can use a CD changer and an amplifier
l
to upgrade your vehicle stereo system.
CD Changer DIN Socket
CD Changer
CD changer DIN Socket
Connect the DIN socket to the CD changer using
l
(lo-disc)", and the "FXD-Cl00 (6disc)" CD changer.
RCA Line-out Jacks (For Rear Speakers)
l
nals of the external amplifier for the rear speakers.
Amplifier, cover the end of the Blue/Red wire with
When fuse replacement is necessary, remove
l
the blown fuse by using pliers. Then install the
new IO amp fuse.
Rear Speaker
a
DIN cable (8 pin) which is supplied with the "FXD-C200
Only)