Personal Identification Number (Pin); Manually Add A Wireless Network - Yealink T41S Quick Reference User Manual

Personal Identification Number (PIN)

To connect to the wireless network using PIN method:
1. Press Menu > Settings > Basic Settings > Wi-Fi
2. Press the WPS soft key, and then select WPS-PIN
3. The LCD screen prompts "Please input below PIN code on your Wi-Fi router and press OK to
connect: xxxx"
4. Log into your gateway/router's web interface, and configure it to search the clients. For
more information, refer to the documentation from the gateway/router manufacturer.
Once WPS-PIN setup has completed successfully, the gateway/router's web interface will
prompt success
Note: Contact your system administrator for more information

Manually Add a Wireless Network

If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results. In
that case, you must manually add a wireless network:
1. Press Menu > Settings > Basic Settings > Wi-Fi
2. Press or
3. Use the WLAN settings obtained from your gateway/router to configure this WLAN Profile
on your IP phone. Do the following:
a. If you select None or WEP from the pull-down list of Security Mode:
Enter the profile name, SSID and WPA shared key in the corresponding fields
b. If you select WPA-PSK or WPA2-PSK from the pull-down list of Security Mode:
Select the desired Cipher type (TKIP, AES or TKIP AES) from the pull-down list of
Cipher Type
Enter the profile name, SSID and WPA shared key in the corresponding fields
4. Press the Save soft key to accept the change or the Back soft key to cancel
Note: The connected wireless networks will be saved to Known Network(s) list. The Known
Network(s) list can store up to 5 wireless networks, you can specify the priority to connect to the
corresponding wireless network.
to highlight Known Network(s), and then press the Add soft key
Optus Loop – Yealink T41S Wireless Settings QRG
Yealink T41S Wireless Settings
4