Using Mypower All Plus; Select/Connect The Adapter Tip - Tekkeon MP3700 User Manual

Using myPower ALL Plus

The main output port (DC OUT) on myPower ALL Plus can be used to power and/or charge any portable
device that requires between 9.5V and 20V (and some power devices that require slightly more voltage).
At the same time or separately, the USB output port can be used to power and charge smaller devices
requiring 5V.
To use myPower ALL Plus to power and/or charge your device, take these steps which are described in
detail in the following sections.
• Select an output adapter tip for your main device and connect the plug to the output cord.
• Connect the power output cord to myPower ALL Plus.
• Connect the power output cord/output adapter tip to your laptop. See Adapters on page 11
for detailed information about the adapter tips.
• Connect a second 5V device using an adapter, or with the device USB cable.
You also can charge your laptop and myPower ALL Plus at the same time by plugging the laptop power
adapter into myPower ALL Plus. In this case, the output current should be less than 5A to power and/or
charge your device.

Select/Connect the Adapter Tip

1. Locate the polarity symbol on your device in the area around the power
connector jack:
WARNING: myPower ALL Plus supports Center Positive polarity only. If your device has a Center
Negative polarity, do not power the device with myPower ALL Plus; contact support@tekkeon.com
for assistance.
USER GUIDE
Center Positive
Center Negative
7