Table of Contents
Advertisement
The following adjustments can be made in this sub-menu:
5.4.1 Switch DiSEqC on or off
DiSEqC (
gital atellite
switch DiSEqC-compatible components via the antenna cable.
If your external unit is equipped with DiSEqC components, you must switch on the DiSEqC-
control:
>
Make adjustments in this line by means of the key
Since only one LNB can be addressed when the DiSEqC control is switched off, the
menu is restricted to the configuration of a single LNB.
5.4.2 Setting the switching matrix and the LNB properties
The menu lists the four switching criteria of the DiSEqC control.
Your receiver has been pre-programmed, so that ASTRA will be received in switch position
A/A and Eutelsat in switch position B/A of a multiswitch. If the switching matrix of your recep-
tion equipment be configured differently, or if it is set to receive other satellites, you can
make the following settings/adjustments in your receiver.
>
Use the
want to allocate to a particular satellite (e.g.
line in blue.
>
Confirm by pressing
A list of various satellites will now be displayed.
>
Use the
The
while using the
If the satellite you are looking for is not specifically listed, select one of the spare posi-
tions, marked as
>
Confirm by pressing
The selected and marked satellite will now be inserted and shown at the previously
marked position in the menu
Continue to work your way through the
corresponds with that of your reception unit. Any switching criteria not required should be set
to the position
5.4.3 Additional settings
Now that you have adjusted the switching matrix of your DVB receiver to correspond with
your reception unit, you should now check the additional parameters of your reception unit,
and, where necessary, make further corrections.
>
Use the
>
Now use the
which you want to check or alter the settings.
>
Confirm by pressing
The menu >
ted (e.g.
uipment
ontrol) is a digital control signal used to control and
dto select the DiSEqC switch position (1-4) that you
.
to mark the satellite selected.
will move the marker up or down one line at a time,
to
.
.
.
will now be displayed, showing the DiSEqC setting selec-
).
will jump to the previous or next page.
.
.
to move the marker to the column
, to mark the field
14
or
.
), by marking this
, until the data in this menu
.in the line in
.
Advertisement
Table of Contents
