Download  Print this page

Troubleshooting; Maintenance - Black & Decker CHV9610 Instruction Manual

Black & decker mixer user manual
Hide thumbs

Advertisement

Table of Contents
90564313 CHV9610 CWV9610 VAC manual.qxd:??????-00 Cir Saw book
• Figure I - While holding the dust bowl over a
wastebasket or sink, pull out the filter to empty
the contents of the bowl.
• Figure J - Empty the dust from the bowl and
wash if necessary.
• Figure K - The dust bowl can also be washed in
warm soapy water. Wash the filter regularly using
warm, soapy water and ensure that it is
completely dry before using it again. The cleaner
the filter is, the better the product will perform.
• Ensure that the dust bowl and filter is dry before
re-attaching.
• It is very important that the filter is correctly in
position before use.
IMPORTANT: Maximum dust collection will only
be obtained with a clean filter and an empty dust
bowl. If dust begins to fall back out of the product
after it is switched off, this indicates that the bowl
is full and requires emptying.
Replacing the filters
The filters should be replaced every 6 to 9 months and whenever worn or damaged.
Replacement filters are available from your Black & Decker dealer.
Visit www.blackanddecker.com to locate dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.

Maintenance

Bowls and filters can be washed thoroughly; however, use only mild soap and a damp
cloth to clean the main part of the vacuum.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
I
J
K
6
5/10/10
11:30 AM
Page 6

Troubleshooting

If the product does not work, check the following:
• The charge indicator light is on when unit is connected to charger.
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached.
• The charger is plugged into a working electrical outlet.
• The switch is in the "OFF" position when charging.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Accessories
Recommended accessories for use with your product are available from your local dealer
or authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
this product could be hazardous.
BATTERY REMOVAL AND DISPOSAL
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries.
When the batteries no longer hold a charge, they should be removed from the Vac and
recycled. They must not be incinerated or composted.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or
Authorized Service Center. Some local retailers are also participating in a national
recycling program (see "RBRC
the batteries to a Black & Decker Company-Owned or Authorized Service Center, the
Center will arrange to recycle old batteries. Or, contact your local municipality for
proper disposal instructions in your city/town.
To remove the battery pack for disposal:
1.) First, before attempting to disassemble the product, turn it on and leave it on until
the motor completely stops insuring a complete discharge of the batteries.
2.) Using a phillips screwdriver, remove the seven screws securing the two housing halves.
3.) Lift the housing cover away from the assembly.
4.) Detach all lead connections from the battery pack.
5.) Remove battery pack and dispose of as per recommended guidelines.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the costs to
recycle the battery (or battery pack) at the end of its useful life have already been paid
by Black & Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in
the trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-
cadmium batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized Black & Decker service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.
The use of any accessory not recommended for use with
TM
Seal"). Call your local retailer for details. If you bring
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cwv9610Cwv9610d