Connecting SBUS Modules to the 5895XL
3.3.1 Setting the Device ID
board to set the module ID#. Figure 2.3 shows the location of the DIP switch on the board.
3.4 Connecting SBUS Modules to the 5895XL
1.
Connect SBUS modules to the 5895XL as shown in Figure 3.10 or Figure 3.11.
2.
All SBUS modules must have an ID. Use the DIP switches on the module board to assign an ID number (1-31) to the module. This
number identifies the module to the 5895XL and must be unique.
5895XL Manual - P/N 151142-L8:L 08/09/2017
Figure 3.9 Possible Module Addresses
Hardware Installation
21