Wiring Product - Mitsubishi Electric Melsec iQ-R Series User Manual

Laser displacement sensor control module for programmable controller
Hide thumbs Also See for Melsec iQ-R Series:
Table of Contents

Advertisement

6.3

Wiring Product

This section describes the wiring products used for the control module.
Applicable wire
For the wire to be connected to the terminal block, use the following.
Size
24 to 14 AWG (stranded wire)
Bar solderless terminal
Use bar solderless terminals that satisfy the following conditions:
Type
Bar solderless terminal
Bar solderless terminal
tool
Bar solderless terminal
Bar solderless terminal
tool
Precautions
• Always turn off the power before proceeding with attachment or removal of wiring and the terminal block.
• Do not use wires with a soldered end. Poor contact or insertion/extraction failure to the spring clamp terminal block may
occur depending on the finished quality of the soldering.
• Do not use bar solderless terminals without insulation sleeve.
6 INSTALLATION AND WIRING
36
6.3 Wiring Product
Conductor cross-section area
0.25 to 2.0
Model name
Applicable wire size
AI 0.25-10YE
0.25
AI 0.34-10TQ
0.34
AI 0.5-10WH
0.5
AI 0.75-10GY
0.75
AI 1-10RD
1.0
AI 1.5-10BK
1.5
AI 2.5-10BU
2.5
CRIMPFOX6
TE 0.5-10
0.5
TE 0.75-10
0.75
TE 1.0-10
1.0
TE 1.5-10
1.5
TE 2.5-10
2.5
NH 79A
Material
Copper
Contact
PHOENIX CONTACT GmbH & Co. KG
NICHIFU Co.,Ltd.
Temperature rating
75 or greater

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec iq-r melsensor

Table of Contents