Configuration of Laser Displacement Sensor
The following figure shows the system configuration of the control module.
(1) Engineering tool, setting tool
(2) Control module
(3) Sensor head A
(4) Sensor head B
(5) External power supply
For applicable combinations of CPU modules and the other modules and for the number of mountable
modules, refer to the following.
MELSEC iQ-R Module Configuration Manual
• When connecting one sensor head to the control module, connect the sensor head to the SENSOR HEAD A connector.
When one sensor head is used and it is connected to the SENSOR HEAD B connector, measurement cannot be
• Be careful of the incorrect wiring when connecting each device. For the wiring, refer to the following.
Page 32 Wiring Method
5.1 Configuration of Laser Displacement Sensor
5 SYSTEM CONFIGURATION