Remote Control Operation - Sanyo DP50747 Owner's Manual

POINT
TOWARDS TV
INPUT
Œ
1

4
7
INFO
RECALL
MENU
Ž
CAPTION

CH
PIX SHAPE AUDIO


REMOTE CONTROL OPERATION

POWER
2 3
5 6
8 9
SLEEP
0
1-- MUTE
ENTER
EXIT
VOL
RESET
Œ
Input Key—Press to select the program source
to watch: Analog RF ¬ Digital RF ¬ Video 1 ¬ Video
2 ¬ Video 3 ¬ HDMI 1 ¬ HDMI 2 ¬ HDMI 3 ¬
Analog RF.

Number Keys—Two keys must be pressed to
select a direct channel. Example: Press 0 then 6 to
select channel 6. (See item #5 below.)
Note:Numerical direct channel selection works for
either Analog or Digital channels in memory but
not both at the same time.
Ž
Menu Navigational Keys:
Menu—Press to display on-screen menu.
Cursor L (up) M (down) keys—Press these keys to
move the cursor up and down within the menu.
Cursor < (left) > (right) keys—Press these keys to
move the cursor left and right within the menu.
Enter Key—Press to select an option from the menu
system, when required.
Exit Key—Press to exit from the menu system.

Channel Scanning (CH LM) Keys—Press to scan
through the channels in memory.
Volume Keys—Press VOL – + to adjust.

PIX Shape Key—Use to change the video display
format. Available options depend on signal received
and the broadcast's aspect ratio.
Note: If you cannot display picture on a full screen,
press the PIX Shape key to change setting.
(CONTINUED ON NEXT PAGE.)
28